Sharp FO-5700 - Manual (Page 152)

Optional Settings
150
Setting 26: TELEPHONE BILLING CODE
This setting allows you to use Department Codes or direct billing
codes for telephone billing on a PBX. (Your dealer must first activate
Department Control or direct billing code entry.) Press 1 to turn
telephone billing on, or 2 to turn it off.
♦
Initial setting: 2
If you pressed 1, the BILLING CODE DIAL selection will
subsequently appear. Press 1 if your PBX must receive the billing
code before dialing a telephone number, or 2 if it must receive the
billing code after dialling a telephone number. (Refer to your PBX
manual or consult your PBX adminstrator for this information.)
Note: If you select AFTER for the BILLING CODE DIAL selection, you
must press the REDIAL key after dialing if you use the SPEAKER key.
Setting 27: DEPARTMENT CODE DIGITS
Use this setting if you are using Telephone Billing and need to change the
number of digits of Department Codes to accord with your PBX’s tele-
phone billing system. Enter any number from 3 to 9.
♦
Initial setting: 4
Setting 28: DISTINCTIVE RING
This sets the ring pattern to which your fax will answer if you subscribe
to a distinctive ring service. Enter a number from 1 to 5 to select a pat-
tern. See Distinctive Ring in Chapter 5 for more details.
♦
Initial setting: 5
all-FO4700.book Page 150 Friday, June 11, 1999 1:57 PM