Sharp FO-5700 - Manual (Page 151)

Optional Settings
149
6. O
p
tion
Settings
Setting 21: ALARM VOLUME
This sets the volume of the beep sound that alerts you to error
conditions and informs you that operations have been completed.
Press 1 for HIGH, 2 for LOW, or 3 for OFF.
♦
Initial setting: 2
Setting 22: DIAL MODE
This sets the dial mode. Press 1 if you are on a touch-tone line, or 2 if
you are on a pulse dial (rotary) line.
♦
Initial setting: 1
Setting 23: QUICK ON-LINE
When you transmit a multi-page document, this setting determines
whether the fax machine will dial the receiving party and begin
transmitting while scanning is still in progress, or wait until all pages
have been scanned before dialing. Press 1 to have the fax machine dial
and begin transmission while scanning is still in progress, or 2 to have
the fax machine wait until all pages have been scanned.
♦
Initial setting: 1
Setting 24: MULTI TTI
If you are using Department Control, you can press 1 to have the
department name (the name associated with the department code
entered by an operator to access the fax) appear at the top of each
transmitted document. This will appear in place of the name entered
in Entering Your Name and Fax Number in Chapter 1. Press 2 to turn
Multi TTI off (the sender’s name entered in Chapter 1 will appear).
♦
Initial setting: 2
Setting 25: BEEP LENGTH
This sets the duration of the beep that signals the end of transmission,
reception, or copying. Press 1 for 3 seconds, 2 for 1 second, or 3 for
no beep.
♦
Initial setting: 1
all-FO4700.book Page 149 Friday, June 11, 1999 1:57 PM