Juniper Networks EX8208 - Manual (Page 54)

Table 11: Link/Activity LED on the Management Port on EX8200 Switches
State and Description Color LED
• Blinking—The port and the link are active, and there is link
activity.
• On steadily—The port and the link are active, but there is no
link activity.
• Off—The port is not active.
Green Link/Activity
Table 12 on page 28 describes the Status LED (administrative status).
Table 12: Status LED on the Management Port on EX8200 Switches
State and Description Color LED
• On steadily—Administrative status is enabled.
• Off—Administrative status is disabled.
Green Status
Related Topics See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch on page 24
for port location. •
• See Routing Engine (RE) Module in an EX8216 Switch for port location.
• Connecting an EX Series Switch to a Network for Out-of-Band Management on page 187
Switch Fabric (SF) Module in an EX8208 Switch
The Switch Fabric (SF) module provides switching functionality. See Figure 10 on page 28.
An EX8208 switch can have either zero SF modules or one SF module. The base
configuration of an EX8208 switch includes one SF module. See “EX8208 Switch
Configurations” on page 6.
Figure 10: SF Module in an EX8208 Switch
The SF module can be installed only in the slot labeled SF. The SF module is keyed so
that it does not fit in the other slots in the chassis. See “Slot Numbering for an EX8208
Switch” on page 13.
Copyright © 2010, Juniper Networks, Inc. 28
Complete Hardware Guide for EX8208 Ethernet Switches