JVC UX-F70MD - Manual (Page 35)

– 30 –
English
Before You Start Recording on an MD
• It may be unlawful to record or play back copyrighted material without the consent of the
copyright owner.
• When you record onto a partially recorded MD, its contents are not erased or overwritten. The recording starts from
the point following the last recorded track of the MD. If you want to record on such an MD from the beginning, you
have to erase its contents first (see “Erasing All Tracks — ALL ERASE” on page 52.)
• When an MD is fully recorded, recording will stop automatically.
• The recording level is automatically set correctly, so it is not affected by the VOLUME control. Thus, during
recording you can adjust the sound you are actually listening to without affecting the recording level.
• While recording, you can hear sound mode effect and/or the Active Hyper Bass Pro effect through the speakers or
headphones. However, the sound is recorded without these effects (see pages 12.)
• You can make a digital-to-digital recording from a CD onto an MD. When selecting FM, AM, TAPE or AUX as the
source, you can make an analog-to-digital recording only.
• You cannot record more than 254 tracks onto an MD, though there is a still enough remaining recording time on it.
• The display turns red while recording is performed.
About the track marks
When playing an MD, you can move among the tracks.
You can do this because there is a mark recorded at the
beginning of each track enabling you to locate the track.
This mark is called a “track mark” and the portion
between two adjacent track marks is called a “track.”
• When recording from the CD player, a track mark
is recorded automatically at the beginning of each
track.
• When recording from an analog source such as
FM/AM broadcasts, no track mark is recorded on
the MD. This means that, when playing this MD, the
MD recorder will regard the entire recording as one
track (track 1.) You will not be able to select directly
a song or navigate through songs.
However, if there is a blank of 3 seconds or more, the
MD recorder will consider it as a blank separating 2
tracks and consequently put a track mark.
To put a track mark manually while recording an
analog source, press SET on the remote control at the
place you want to put a track mark.
To add a track mark after recording is over, you can
use the DIVIDE function (see page 50.)
Erasure prevention tab
Disc protected:
Recording/Editing
not possible Recording/Editing
possible
To avoid erasing important recordings
The recordable MD has an erasure prevention tab so
that important recordings are not accidentally erased.
When you finish recording or editing, slide to open the
erasure prevention tab on the cartridge side surface.
New recording or editing is now no longer possible. (If
you try to do, “DISC PROTECTED” appears on the
display.)
To do re-recording or editing, return the tab to the
closed position.
If “PLAYBACK DISC” appears on the display
when you try to record on an MD
The MD is only for playback use, not for recording.
Continued
EN29-39UX-F70MD[UB]_f 01.7.10, 2:59 PM 30