JVC UX-F70MD - Manual (Page 13)

– 8 –
English
R L
– –
+ +
R L
SPEAKER IMPEDANCE
MIN 4 Ω
Connecting Other Equipment
You can connect the following equipment which can be
used as a playback device.
When you connect and use the equipment, refer also to its
manual supplied.
• DO NOT connect other equipment while the
power is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect another component such as analog audio
equipment
Be sure that the plugs of the audio cords and the jacks on
the rear of the unit are color-coded: White plugs and jacks
are for left audio signals, and red ones for right audio
signals.
For playing the other equipment through this unit,
connect between the audio output jacks on the other
equipment and LINE IN (AUX) jacks by using audio cords
(not supplied.)
To connect speakers
You can connect the speakers by following the procedure
below.
1
If cords are covered with insulation, twist the core
of the cord at the end of each cord, then remove the
insulation.
2
Open the speaker terminal.
3
Insert the end of the speaker cord to the terminal.
Match the polarity: White cord to red (+) terminal and
black cord to black (–) terminal.
4
Close the speaker terminal on the rear of the unit.
Use only speakers with the speaker impedance — 4
Ω
to
16
Ω
.
Speaker cord
Speaker cord
Black
Rear of the right
speaker Rear of the left
speaker
Red
1
Speaker terminals 3,4 2
To output
Ex. Analog audio
equipment
Continued
R
SPEAKER IMPEDANCE
L
MIN 4
R L
A C I N
LINE IN
(AUX)
EN01-09UX-F70MD[UB]_f 01.7.10, 2:56 PM 8