JVC UX-F70MD - Manual (Page 17)

– 12 –
English
Adjusting the Volume
You can adjust the volume level only while the unit is
turned on. The volume level has no effect on recording.
To increase the volume, press VOLUME + .
To decrease the volume, press VOLUME – .
The volume level meter appears on the display.
• The volume level can be adjusted in 41 steps (VOL MIN,
VOL 1 – VOL 39, and VOL MAX.)
• When pressing and holding the button, you can change
the volume level continuously.
For private listening
Connect a pair of headphones to the PHONES jack. No sound
comes out of the speakers. Be sure to turn down the volume before
connecting or putting on the headphones.
If “CANNOT LISTEN!” appears on the display
During high-speed recording (see page 31), you cannot listen to
any source, and therefore, cannot adjust the volume level.
DO NOT turn off (on standby) the unit with the
volume set to an extremely high level; otherwise, the
sudden blast of sound can damage your hearing,
speakers and/or headphones when you turn on the
unit or start playing any source.
REMEMBER you cannot adjust the volume level
while the unit is in standby mode.
Reinforcing the Bass Sound
The richness and fullness of the bass sound is clearly
maintained regardless of how low you set the volume —
Active Hyper Bass Pro. The AHB PRO effect can be
applied only to playback sounds, and cannot be used for
recording.
On the remote control ONLY:
To get the effect, press AHB PRO.
The AHB PRO indicator lights on the display.
• Each time you press the button, the effect changes as
follows:
AHB 1: Bass sound is clearly heard even in the low
volume.
AHB 2: More richness and fullness of the bass sound
is heard.
AHB OFF: Cancels the AHB PRO effect.
The AHB PRO indicator goes off from the
display.
To check the AHB PRO setting currently selected, press
AHB PRO once while the AHB PRO indicator is lit.
Selecting the Sound Modes
You can select one of the 4 preset sound modes. The sound
modes can be applied only to playback sounds, and cannot
be used for recording.
On the remote control ONLY:
To select the sound modes, press SOUND MODE
repeatedly until the sound mode you want appears on the
display.
The SOUND indicator also lights on the display.
• Each time you press the button, the sound mode changes
as follows:
ROCK: Boosts low and high frequency.
Good for acoustic music.
POP: Good for vocal music or voice.
CLASSIC: Good for classical music.
JAZZ:
Good for jazz music.
FLAT: Cancels the sound mode.
The SOUND indicator goes off from the
display.
To check the sound mode currently selected, press
SOUND MODE once while the SOUND indicator is lit.
(Maximum)
(Minimum)
ROCK POP CLASSIC
JAZZ FLAT
(Canceled)
AHB 1 AHB 2
AHB OFF
(Canceled)
Turning On/Off the Key-touch Tone
You can deactivate the key-touch tone if you do not want it
to beep each time you press the button.
On the remote control ONLY:
Press BEEP.
• Each time you press the button, the key-touch tone turns
on (BEEP ON) and off (BEEP OFF) alternately:
BEEP ON BEEP OFF
Continued
EN10-13UX-F70MD[UB]_f 01.7.10, 2:57 PM 12