JVC SR-VD400E - Manual (Page 9)

EN
9
IN F-1
+
C
B
Basic
Playback
Features Checking tape position
The tape position indicator
appears on the screen in the
following cases:
● When you change the VCR
operation mode from the
stop mode to fast forward
or rewind mode.
● When you perform an
Index Search ( ੬ page 11).
The position of “ ” in relation to “B” (Beginning) or “E”
(End) shows you where you are on the tape.
NOTES:
● “SUPERIMPOSE” must be set to “ON”, or the indicator will not
appear (
੬ page 39).
● It may take a few seconds for the tape position indicator to be
displayed.
To reset the time counter, press [C. RESET] on the Remote.
The counter reading becomes “0:00:00”. It is also reset
when a tape is inserted.
B
A
● Turn on the VCR and the TV, and select the AV mode
on the TV.
● Set the [VCR/TV/CABLE/DBS] selector on the Remote
to [VCR].
VCR
TV
CABLE
/DBS
[STOP ( 7 )]
[POWER]
[FF ( ¡ )]
[SKIP SEARCH]
[REW ( 1 )]
4 ¢
[C.RESET]
B
C
D
E G
H
[ ] [ ]
B E
Playing back tape repeatedly
— Repeat Playback
You can play back a tape repeatedly (50 times).
While playing back a tape, press and hold [PLAY ( 3 )] for
more than 5 seconds.
The play indicator [
#] on the front display panel starts
flashing slowly, and a tape will be played back 50 times.
To stop playback, press [STOP (
7 )] on the Remote or
[STOP/EJECT ( 7 / 0 )] on the front panel.
NOTE:
For a cassette recorded in D-VHS mode, Repeat Playback is not
possible if the cassette was recorded in LS3 or LS5 mode.