JVC SR-VD400E - Manual (Page 46)

46
EN
A/B/C/D
ABC
STOP
VCR
TV
CABLE
/DBS
2
- 2
2
- 1
5
2
- 3
1
IN F-1
+
[POWER] [PLAY ( 3)]
The Remote is capable of controlling four JVC video
recorders independently. Each of VCRs can respond to one
of four codes (A, B, C or D).
This Remote control is preset to send A code signals because
your VCR is initially set to respond to A code signals. You
can easily change your Remote and the VCR to send and
respond to B, C or D code signals.
When using four JVC VCRs, set the four VCRs and their
Remotes to different codes, so that the Remotes can operate
these VCRs separately.
1 Set remote operation mode
Set the [VCR/TV/CABLE/DBS] selector to [VCR].
2 Set remote control code for Remote
1 Press and hold [A/B/C/D].
2 Press the ‘Number’ key [1] for A code control
signals, [2] for B code control signals, [3] for
C code control signals and [4] for D code
control signals.
3 Press [STOP ( 7 )], and release [A/B/C/D].
3 Turn off VCR
Press [POWER] on the VCR.
4 Check remote control code for VCR
Press [PLAY ( 3)] on the VCR for more than 5
seconds.
● The code currently set appears on the front
display panel.
5 Turn on VCR
Press [POWER] on the Remote.
● The code transmitted from the Remote blinks
for a few seconds on the front display panel.
● After the code disappears on the front display
panel, make sure that the VCR is turned on by
pressing [POWER] on the Remote.
To control four VCRs with the same Remote
You can control four JVC VCRs by switching the remote
control code for the Remote between A, B, C and D
(
੬ step 2), keeping four VCRs to different control codes.
● Press the ‘Number’ key [1] for A code control signals, [2]
for B code control signals, [3] for C code control signals
and [4] for D code control signals. (To change only the
remote control code for the Remote, DO NOT perform
steps 3 to 5.)
Changing
Remote Control
Code
(Ex.) To set Remote to B code:
Press in succession Hold
down
Release
NOTE:
When “POWER SAVE” is set to “ON”, you can not change the
remote control code. Before changing the code, set “POWER
SAVE” to “OFF” (
੬ page 39).
MULTI-BRAND REMOTE CONTROL (cont.)