Intel KEMX-2030 - Manual (Page 59)

Appendix B
59 KEMX-2030 User’s Manual
How to run the test program:
Click on “Start”->”All Programs”->”Quanmax DIO Tool”->”DIO TOOL” to start
the DIO test program
The test tool is launch.
All output will be set to low as default value when program initialized.
Click on “Switch Output” button can switch the corresponding output.
The input readings will only be update by hitting the “Read Input” button.
CN3 to DIO Program look up table:
Pin # 2 4 6 8 10 (GND)
DIO Input# 0 1 2 3 --
Pin # 1 3 5 7 9 (+5V)
DIO Output # 0 1 2 3 --