Intel GA-N650SLI-DS4 - Manual (Page 25)

Hardware Installation - 25 -
English
9) IDE1/IDE2 (IDE Connector)
An IDE device connects to the computer via an IDE connector. One IDE connector can connect to
one IDE cable, and the single IDE cable can then connect to two IDE devices (hard drive or optical
drive). If you wish to connect two IDE devices, please set the jumper on one IDE device as Master
and the other as Slave (for information on settings, please refer to the instructions located on the IDE
device). Before attaching the IDE cable, please take note of the foolproof groove in the IDE connector.
40 39
2 1
40 39
2 1
IDE2 IDE1
10) SATAII0/1/2/3 (SATA 3Gb/s Connector)
SATA 3Gb/s can provide up to 300 MB/s transfer rate. Please refer to the BIOS setting for the Serial
ATA and install the proper driver in order to work properly.
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
1
7 1
7
SATAII2
SATAII3
1
7 1
7
SATAII0
SATAII1