Insignia NS-42 - Manual (Page 24)

24
Insignia NS-42LCD 42-inch LCD TV
www.insignia-products.com
Memorizing channels
When you turn on the TV for the first time, you
should perform an auto channel search to set up
stations on your TV. Before you perform an auto
search, you should select the correct TV source.
Selecting the TV source
Before your TV can memorize the available
channels, you must specify the type of signal
source that is connected to the TV. (For
example, an antenna or cable system.)
To select a source:
1 In single window status (with no
picture-in-picture setting active), press MENU
to display the Main Menu.
2 Press or to display the CHANNEL
SETUP menu page, then press to enter
the menu.
3 Press or to select TV Source, then
press or to select AIR or CABLE.
• Select AIR if using an antenna.
• Select CABLE if using Cable TV.
Auto channel search
You should perform an auto search to search for
available broadcast and cable/set-top box
channels. After the TV finishes searching for
channels, the TV stores the valid channels in
memory.
•
If TV Source is set to AIR, highlight Auto
Search, then press or . The TV begins
searching for all available TV or DTV
channels.
- OR -
If TV Source is set to CABLE, highlight Auto
Search, then press or . The Channel
Scan Source window opens.Press or to
select STD (the most common type of
Cable TV), HRC, or IRC, then press OK to
begin the auto channel search. The TV
begins searching for all available CATV or
CADTV channels.
Skipping channels
After saving channels into memory, you can skip
unnecessary channels so that only the channels
you want to watch are selected with the CH+/-
buttons.
To skip channels:
1 Open the CHANNEL SETUP menu.
2 Highlight Current Channel, then press or
to select an unwanted channel.
3 Highlight Channel Skip, then press or to
change the setting to ON.
4 If you want to skip other unwanted channels,
repeat Steps 2-3.
5 Press EXIT to exit. The channels you
specified will be skipped the next time you
press the CH+/- buttons.
Note
If a picture-in-picture mode is active, your TV
cannot do an auto search.
Note
If you want to stop the auto search, press MENU.