Intel 537EX - Manual (Page 55)

536EX Chipset Developer’s Manual 55
Intel Confidential
Data Mode AT COMMANDS
+PMHT=m 0
Modem on Hold Timer: This command controls whether or not the modem will grant or deny a Modem
on-hold (MOH) request as well as setting the Modem-on-Hold-Time-Out.
0 Deny V.92 Modem-on-hold Request
1 Grant MOH with 10 second time-out
2 Grant MOH with 20 second time-out
3 Grant MOH with 30 second time-out
4 Grant MOH with 40 second time-out
5 Grant MOH with 1 minute time-out
6 Grant MOH with 2 minute time-out
7 Grant MOH with 3 minute time-out
8 Grant MOH with 4 minute time-out
9 Grant MOH with 6 minute time-out
10 Grant MOH with 8 minute time-out
11 Grant MOH with 12 minute time-out
12 Grant MOH with 16 minute time-out
13 Grant MOH with indefinite time-out
+PQC=m 0
V.92 Phase 1 and Phase 2 Control: This command controls the global enabling or disabling of the V.92
shortened Phase 1 and Phase 2 startup procedures, not the initiation thereof. This command is used in
conjunction with the +PSS command.
0 Enable Short Phase 1 and Short Phase 2
1 Enable Short Phase 1
2 Enable Short Phase 2
3 Disable short Phase 1 and Short Phase 2
+PSS=m 2
Use Short Sequence: This command causes a calling DCE to force either a V.92 short or full startup
sequence as defined by the +PQC command on the next and subsequent connections.
0 The DCEs decide whether or not to use the short startup procedures. The short startup
procedures shall only be used if enabled by the +PQC command.
1 Forces the use of the short startup procedures on the next and subsequent connections if
they are enabled by the +PQC command.
2 Forces the use of the full startup procedures on the next and subsequent connections
independent of the setting of the +PQC command.
Table 18. Data Mode Command Descriptions (Continued)
Command Default Description
NOTE: An asterisk (*) denotes the factory-default setting.