Table 6. v.44/v.42/v.42 bis mnp command summary, V.44/v.42/v.42 bis mnp command summary, Intel confidential – Intel 537EX User Manual
Page 19
536EX Chipset Developer’s Manual
19
Intel Confidential
AT Command Summary Tables
Note:
See the relevant sections in the 536EX Developer’s Manual for full command description and
parameter ranges.
a. For Data mode, the factory default setting is AT+MS=V92, 1, 0, 0, 0, 0 to send at speeds of 33,600 bps or
below and receive at speeds of 53,333 bps and below.
Table 6. V.44/V.42/V.42 bis MNP Command Summary
Note
Command
Function
Default
Range
Reported
by &Vn
*
%An
Set auto-reliable fallback character
13
0–127
yes
*
%Cn
MNP 5 data compression control
1
0, 1
yes
%C0
No compression
%C1
Enables MNP5 data compression
*
\An
MNP block size
3
0–3
yes
\A0
Maximum 64 characters
\A1 Maximum
128
characters
\A2
Maximum 192 characters
\A3
Maximum 256 characters
\Bn
Set transmit break
3
0–9
*
\Cn
Set auto-reliable buffer
0
0–2
yes
\C0
No data buffering
\C1
Four-second buffer until 200 characters in the buffer or
detection of a SYN character
\C2
No buffering. Connects non-V.42 modems to V.42
modem
*
\Gn
Set modem port flow control
0
0, 1
yes
\G0
Disables port flow control
\G1
Sets port flow control to XON/XOFF
*
\Jn
bps rate adjust control
0
0, 1
yes
\J0
Disables rate adjust
\J1
Enables rate adjust
\Kn
Set break control
5
0–5
no
\K0
connect state, transmits
Enters command mode,
no break sent
command state, transmits
Destructive/expedited
connect state, receives
\K1
connect state, transmits
Destructive/expedited
command state, transmits
connect state, receives
*
Value saved in NVRAM.