Intermec CN2G - Manual (Page 29)

Chapter 1 — Using the CN2G Handheld Computer
CN2G Handheld Computer User’s Manual 17
Using the SD Card
You can use a Secure Digital (SD) card to increase file storage
and install software. The CN2G currently supports SanDisk SD
cards only.
The CN2G ships with a 256MB SD card installed. The SD card
slot is located under the battery in the battery compartment of
the CN2G.
To remove the SD card
1 Press and hold the Power key for approximately 2 seconds,
and then release it to turn off the CN2G.
2 Place the CN2G face-down on a clean, flat, stable surface.
3 Push down on the battery door latch, and pull up on the
battery door.
Battery
door
latch
4 Remove the battery door and set it aside.
5 Insert the stylus between the battery and the CN2G case, and
press straight down until the battery is released.