IBM 09-0572-000 - Manual (Page 66)

When Tests Fail 7-11
The following information is displayed on the screen,
indicating what to do when the specific test fails.
MMIO Register Write/Read Test Failure
■
Check the ROM base address setting on the adapter and
make sure that it is not being used by another device.
■
Run the test three times with a delay of at least 30 seconds
between each test. If the error persists, power down the PC
and try once more.
Boot PROM Test Failure
■
Check the ROM base address setting on the adapter and
make sure that it is not being used by another device.
■
Refer to the “Configuration Options” section in Appendix B
for more information.
AIP Checksum Test Failure
■
Check the ROM base address setting on the adapter and
make sure that it is not being used by another device.
■
Run the test three times with a delay of at least 30 seconds
between each test. If the error persists, power down the PC
and try once more.
Shared RAM Boundary/Domain Test Failure
■
Make sure the RAM base address is aligned according to the
selected shared RAM size.
■
Make sure the shared RAM address does not conflict with the
adapter ROM or another device.