IBM 09-0572-000 - Manual (Page 58)

Using the TokenDisk Diskette Diagnostic Program 7-3
If you have already installed the network driver, you need to
reboot and press [F5] or use a DOS diskette to bypass the
drivers before you run the diagnostic program. Use a DOS
diskette if you are running DOS 5.0 or earlier. If you are
running Windows NT, boot the DOS partition or boot from a
DOS diskette to run the diagnostic program. If you are
running Windows 95, exit Windows 95 and restart the PC in
MS-DOS mode.
Figure 7-2 depicts how to use the TokenDisk diskette
diagnostic program.
Figure 7-2 Diagnostic Flowchart
Type: 3TOKDIAG
Insert TokenDisk diskette
Make diskette drive active
Select test
Select Run Tests
Standard test ?
No (Custom)
Select Test Setup
Yes