17 serial ata raid connector (sata_raid1) – Intel AX965Q User Manual

Page 50

Text mode
Original mode

ATX Main board

1.8.2.17 Serial ATA RAID Connector (SATA_RAID1)

This connector is for a Serial ATA signal cable. This connector supports a Serial ATA hard

disk drive, which you can combine with an external Serial ATA hard disk drive to configure

for RAID via the onboard Serial ATA RAID controller.

The JMicron controller mode item in the BIOS is set to [IDE] by
default. When set to [RAID], this item allows you to use the connectors
to build a RAID set.

Before creating a RAID set using Serial ATA hard disks, make sure
that you have connected the Serial ATA signal cables and installed
Serial ATA hard disk drives; otherwise, you cannot enter the JMicron®
JMB363 RAID utility and SATA BIOS setup during POST.