IBM Infoprint M22 MFP - Manual (Page 55)

compliant. An FCC compliant telephone cord is
provided with this equipment. Refer to the setup
documentation for instructions about connecting
the fax telephone cable.
If you experience problems with this equipment that
you cannot resolve, contact Lexmark International,
Inc., for repair and warranty information. If the
problems are causing harm to the telephone
network, the telephone company may ask you to
disconnect the equipment from the network until the
problem is resolved. If the equipment causes harm
to the telephone network, the telephone company
will notify you in advance, or as soon as possible,
that temporary discontinuance of service may be
required. You will also be notified of your right to file
a complaint with the FCC if you believe it is
necessary.
The telephone company may make changes to its
facilities, equipment, operations, or procedures that
could affect the operation of this equipment. If this
happens, the telephone company will notify you in
advance so you can make necessary adjustments
in order to maintain uninterrupted service.
This equipment cannot be used on telephone
company-provided coin service.
Connection to party lines is subject to state tariffs.
To avoid damage caused by lightning strikes and
other electrical surges, we recommend that you
install an ac surge protector in the outlet to which
this device is connected.
The Telephone Consumer Protection Act of 1991
makes it unlawful to send a fax unless the following
information is included (1) in a margin at the top or
bottom of each transmitted page, or (2) on the first
page of the transmission:
• Date and time the fax is sent
• Identification of the business, other entity, or
individual sending the fax
• Telephone number of the sending machine
or such business, other entity, or individual
Industry Canada CS-03 notice
Notice: This equipment meets the applicable
Industry Canada Terminal Equipment Technical
Specifications. This is confirmed by the registration
number. The abbreviation, IC, before the
registration number signifies that registration was
performed based on a Declaration of Conformity
indicating that Industry Canada technical
specifications were met. It does not imply that
Industry Canada approved the equipment. The
registration number is located on the equipment.
The Ringer Equivalence Number (REN) for this
terminal equipment is located on the approved
terminal equipment labeling. The REN assigned to
each terminal equipment provides an indication of
the maximum number of terminals allowed to be
connected to a telephone interface. The
termination on an interface may consist of any
combination of devices subject only to the
requirement that the sum of the Ringer
Equivalence Numbers of all the devices does not
exceed five.
Before installing this equipment, users should
ensure that it is permissible to be connected to the
facilities of the local Telecommunications
Company. The equipment must also be installed
using an acceptable method of connection. The
customer should be aware that compliance with the
above conditions might not prevent degradation of
service in some situations.
A representative designated by the supplier should
coordinate repairs to certified equipment. Any
repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give
the telecommunications company cause to request
the user to disconnect the equipment.
Users should ensure for their own protection that
the electrical ground connections of the power
utility, telephone lines and internal metallic water
pipe system, if present, are connected together.
Notices
49