IBM Infoprint M22 MFP - Manual (Page 10)

Step 2: Assemble paper
handling options
CAUTION: If you are using
a 2000-sheet drawer, a
duplex unit with one or more
input drawers, or more than
one 500-sheet drawer, you
must use either a printer
stand or a caster base.
Preparing the
caster base
CAUTION: The correct
stabilizer screws must be
installed in each optional
drawer and the duplex unit
to secure the printer and
options together.
If you purchased a printer stand, follow the assembly instructions
provided with the stand, and then return to Step 2: “Assemble paper
handling options” in this book.
The caster base is used when placing your MFP on the floor. It
provides mobility and a stable platform for your MFP. There are
different assembly instructions for use with a 2000-sheet drawer, 500-
sheet drawer, or a 250-sheet drawer.
1
Remove all items from the caster base carton.
2
Remove and group the machine screws, washers, stabilizer
screws, and posts from the hardware bag.
3
Determine which screws you need for your configuration and
place the other screws into the bag.
• The six long screws (1) are used with three 500-sheet
drawers. (two with each 500-sheet drawer)
• The six short screws (2) are used with the 2000-sheet
drawer or the 250-sheet drawers.
• The two long posts (3) are used with the duplex unit.
• The two short posts (4) are used when a duplex unit is not
available.
• The two long machine screws (5) are used with the 2000-
sheet drawer.
• The two short machine screws (6) are not used with this
scanner.
Depending on your configuration, some of the stabilizer screws
and posts will not be used.
4
If you have a 2000-sheet drawer, place a lock washer and flat
washer on each of the two long machine screws (5).
Assemble paper handling options
4