IBM Infoprint M22 MFP - Manual (Page 27)

Verifying the IP settings
Note: On Windows
computers, click Start
Programs
Command
prompt (or Accessories
Command prompt if using
Windows 2000).
Attaching the
scanner shelf
3
Press Menu until you see Std Net Setup (or Network 1 Setup or
Network 2 Setup), and then press Select .
4
Press Menu until you see TCP/IP, and then press Select .
5
Press Menu until you see Set IP Address, and then press
Select .
6
Change the address by pressing Menu to increase or decrease
each number. Press Select to move to the next segment. Press
Select when you are finished.
The message Saved appears briefly.
7
Press Menu until you see Set IP Netmask, and then press
Select .
8
Repeat step 6 to set the IP Netmask.
9
Press Menu until you see Set IP Gateway, and then press
Select .
10
Repeat step 6 to set the IP Gateway.
11
When you are finished, press Go to return the printer to the
Ready state.
1
Print another network setup page. Look under the “TCP/IP”
heading and make sure the IP address, netmask, and gateway
are what you expected.
See “Printing a network setup page” on page 20 if you need
help.
2
Ping the printer and verify that it responds. For example, at a
command prompt on a network computer type ping followed
by the new printer IP address (for example, 192.168.0.11):
ping xxx.xxx.x.xx
If the printer is active on the network, you receive a reply.
1
Turn the printer off.
2
Unplug the 16 AWG power cord or printer power cord from the
grounded outlet.
Set up the printer
21