IBM Infoprint M22 MFP User Manual

Page 35

Wait for the MFP to initialize. When the scanner comes on,
there is a short wait cycle while the firmware is initialized.
Please Set Date/Time

is displayed on the first line of the

MFP control panel and “Please Wait...” is displayed on the
second line.

Do not turn off the printer or unplug the scanner until the
Please Wait

... message disappears from the control panel.

First time setup

MFP panel:

Please Set Date/Time

Please Wait

...

When initialization is completed, the

Please

Wait

...

message disappears. The

Please

Set Date/Time

prompt indicates that you

need to set required fax information.

Restart

MFP panel:

Please Wait

...

When you restart the MFP, a

Please Wait

...

message appears on the second line of the
control panel. When initialization is completed,
the MFP control panel displays the current time
and date, plus the

Ready

message.

Printer
operator panel

Printer panel:

24MB of memory required

for Fax

...

When you turn on your printer after installing the
MFP, you may see the message on the left. The
Analog Fax option is disabled unless there is a
minimum 24MB of printer memory.

If you receive this message, install additional
printer memory to meet or exceed the 24MB
requirement.

Hardware setup is now complete. You are ready to configure the MFP.

Turn on the scanner and printer