Minicom Advanced Systems Minicom Smart 116 IP - Manual (Page 37)

USER GUIDE
36
Restore the device firmware – If during a firmware update there is a power
failure and you can no longer access the system you can restore the device
firmware from the Safe mode.
23.1 Entering Safe mode
To enter Safe mode:
1. Press and hold down the Local button for 3-4 seconds and at the same time
power up the Smart 108/116 IP. The device boots up in Safe mode.
2. Wait until the unit finishes booting (1-2 minutes).
3. You need to know the IP address of the Smart 108/116 IP. The IP address
depends on whether there is a DHCP server on the network. If there is, the
DHCP server assigns an IP address to the Smart 108/116 IP. If there is no
DHCP server, the unit boots with the static IP address 192.168.2.155. See
Figure 32 for an overview of this procedure.
Is DHCP Server
present in the connected
LAN?
IP address is assigned by
the DHCP server
Device IP is:
192.168.2.155
Yes
No
Follow the instructions in the user
guide to boot the unit into Safe Mode
To access the configuration page of the unit, open Internet Explorer 6.0 or higher and type:
http://IPaddress/config (*Note: Safe mode is HTTP, not HTTPS)
Default user: admin
Default password: SAFEmode (case sensitive)
Figure 32 Safe mode procedure