Minicom Advanced Systems Minicom Smart 116 IP - Manual (Page 21)

USER GUIDE
20
Note! The following “special” characters: &, <, >, ” cannot be used for either
the user name or password.
Depending on the security level chosen the user name and password parameters
are different. See section 17 on page 22.
2. Select the permission type from the Permission dialog box.
3. Click , the user appears in the list of users.
14.2 Editing a user
To edit a user:
1. Select the user from the list.
2. Click . You can now change all the parameters – user name,
permission and password.
3. Click , the changes are saved.
14.3 Deleting a user
To delete a user:
1. Select the user from the list.
2. Click .
3. Click , the changes are saved.
14.4 Blocking a user
An alternative to deleting a user is blocking a user. This means that the user’s name
and password is stored, but the user is unable to access the system. Check Block to
block a user. Uncheck Block to allow the user access.
15. Administration > Switch Configuration
Give the servers connected to the Smart 108/116 IP unique names, so that users
accessing the system can identify the servers easily.
To do so:
1. From the menu click Switch Configuration. The Switch Configuration window
appears, see Figure 16.