Motorola BACKFLIP 68014710001-A - Manual (Page 52)

50
• If there is a hologram, replace the battery and retry
charging it;
• If the message remains, contact a Motorola authorized
service center.
Important: Motorola’s warranty does not cover damage to the phone
caused by non-Motorola batteries and/or chargers.
Warning: Use of a non-Motorola battery or charger may present a risk
of fire, explosion, leakage, or other hazard.
Proper and safe battery disposal and recycling: Proper battery
disposal is not only important for safety, it benefits the environment.
Consumers may recycle their used batteries in many retail or service
provider locations. Additional information on proper disposal and
recycling may be found on the Web:
• www.motorola.com/recycling
• www.rbrc.org/call2recycle/ (in English only)
Disposal: Promptly dispose of used batteries in accordance
with local regulations. Contact your local recycling center or
national recycling organizations for more information on how
to dispose of batteries.
Warning: Never dispose of batteries in a fire because they may
explode.
Battery Charging
Battery Charging Notes for charging your phone’s battery:
• When charging your battery, keep it near room
temperature. Never expose batteries to temperatures
below 0°C (32°F) or above 45°C (113°F) when
charging.
• New batteries are not fully charged.
• New batteries or batteries stored for a long time may
take more time to charge.
032375o
• Motorola batteries and charging systems have circuitry
that protects the battery from damage from
overcharging.
Specific Absorption Rate (IEEE)
SAR (IEEE) Your model wireless phone meets the governmental
requirements for exposure to radio waves.
Your mobile device is a radio transmitter and receiver. It is designed
and manufactured to not exceed limits for exposure to radio frequency
(RF) energy set by the Federal Communications Commission (FCC) of
the U.S. Government and by the Canadian regulatory authorities. These
limits are part of comprehensive guidelines and establish permitted
levels of RF energy for the general population. The guidelines are
based on standards that were developed by independent scientific
organizations through periodic and thorough evaluation of scientific
studies. The standards include a substantial safety margin designed for
the safety of all persons, regardless of age or health, and to account
for any variations in measurements.
The exposure standard for mobile devices employs a unit of
measurement known as the Specific Absorption Rate (SAR). The IEEE
SAR limit set by the FCC and by the Canadian regulatory authorities is
1.6 watts per kilogram (W/kg), averaged over one gram of tissue. Tests
for SAR are conducted using procedures accepted by the FCC and by
Industry Canada with the mobile device transmitting at its highest
certified power level in all tested frequencies. Although the SAR is
determined at the highest certified power level, the actual SAR level of
the mobile device while operating can be below the maximum value.
This is because the mobile device is designed to operate at multiple
power levels so as to use only the power required to reach the
network. In general, the closer you are to a wireless base station, the
lower the power output.
Before a mobile device is available for sale to the public in the U.S. and
Canada, it must be tested and certified to the FCC and Industry Canada