Motorola WA840G - Manual (Page 27)

SECTION 2 INSTALLATION
2-10 WA840G
INPUT VOLTAGE: +5VDC, 2A
FCC ID: F2NWA840G
FO R HOM E OR OF FICE U SE
Tested To Comply With FCC Standards
MODEL: WA840G
WIRELESS MAC: AB CD EF 01 23 45
MADE IN TAIWAN
MODEL WA840G
PART NUMBER: AAAAAA-BBB-CC
S/N: PPPPMMYJJJSSSSSCAABBCCCC
INPUT VOLTAGE: +5VDC, 2A
FCC ID: F2NWA840G
FOR HOME OR OFFICE USE
Tested To Comply
With FCC Standards
MODEL: WA840G
WIRELESS MAC: AB CD EF 01 23 45
MADE IN TAIWAN
MODEL WA840G
PART NUMBER: AAAAAA-BBB-CC
S/N: PPPPMMYJJJSSSSSCAABBCCCC
MAC address
2 The default setting is motorola appended with the last 3
characters of the Wireless MAC address (an example SSID:
motorola 345) and that no encryption and authentication are
enabled.
3 To configure the initial settings of the access point, please see
Configure your Computers.
Configure Your Computers
For initial configuration, you need to configure the PC’s network
setting to specify a static IP address for the computer that is going to
communicate with the access point.
After initial configuration:
If… Then…
Using DHCP Reconfigure the PC’s settings to Obtain An IP
Address Automatically.
Not using DHCP Continue to use the Static IP settings.
This section includes information on configuring computers with the
following operating systems:
! Windows
®
98SE
! Windows ME
®
! Windows
®
2000
! Windows XP™
Determine the operating system for each computer you will include in
your wireless network and follow the steps to configure the network
settings for that PC.