Motorola WA840G - Manual (Page 25)

SECTION 2 INSTALLATION
2-8 WA840G
Manual Software Setup
If you’d prefer to manually set up your network, use this section to
configure it. This section details the physical connection of the
access point to your network as well as the configuration needed by
your PC.
To set up your wireless network:
! Physically connect and power on the access point
! Configure your PCs
! Enter Wireless Security settings
Wired Connection to Access Point
LAN Antenna
Reset
Power
If you are connecting your PC with an Ethernet cable to the access
point, your PC must be installed first with an Ethernet adapter.
You need one Ethernet cable for this procedure, to connect the PC to the access
point.
1 Using the supplied Ethernet cable, connect one end of the cable
to your PC’s Ethernet adapter and the other end to the LAN port
on the access point.
2 To configure the initial settings of the access point, please see
Configure your Computers.