Motorola PR400 User Manual
Page 80

August, 2004
6881096C24-A
7-12 Limited Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
6.
Attach the flex cable connector into the connector on the keypad board, if not already connected.
7.
Bend the flex cable connector as shown (
).
7.4.3.4 Keyboard Retainer Re-assembly
1.
Insert the flex cable connector through the slot at the bottom of the keyboard retainer (
Figure 7-
16
).
2.
Insert the two top tabs of the keyboard retainer into the two tab retainers located on each side of
the speaker in the front housing (
Figure 7-16
).
3.
Press the four keypad retainer locking tabs into the housing.
4.
Push the speaker and microphone wires into the top left hand corner of the housing.
7.4.3.5 Chassis Assembly/Re-assembly
1.
Replace the battery contact seal (if necessary) surrounding the battery contact (
Figure 7-17
).
2.
Remove the old Interface Pad from the chassis by scraping off the pad and adhesive with a
straight razor. Use rubbing alcohol and a cloth to completely remove the adhesive from the chas-
sis surface. With the chassis clean and dry, add a new Interface Pad to the chassis.
3.
Place the main circuit board straight down on top of the chassis with the frequency and volume
switches facing down (
Figure 7-17
).
4.
Use the T6 Torx screwdriver to fasten the screws holding the main board to the chassis. Tighten
to 3.7 - 3.9 in/lb.
CAUTION:
Make sure the microphone and speaker wires are not trapped under the LCD mod-
ule.
Figure 7-16. Keyboard Retainer Re-assembly
Note:
Be sure the battery contact seal protrudes through the chassis and is not pinched under the
chassis.
!