Motorola PR400 - Manual (Page 56)

July, 2004 6881096C24-A
6-6 Full Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
6.4.1.2 Dust Cover Disassembly
1. Gently pry the top of the dust cover away from the body of the radio. (See Figure 6-6 ).
2. Rotate the dust cover 90
°
in a counterclockwise direction to allow the key to be removed.
3. Separate the dust cover away from the body of the radio. The dust cover key is fragile; apply only
light pressure to the key while removing the dust cover.
Figure 6-6. Dust Cover Disassembly
6.4.1.3 Speaker and Microphone Disassembly
1. Remove the screw from the speaker retainer using a T6 Torx screwdriver ( Figure 6-7 ).
2. Lift the retainer off the speaker, sliding end of retainer out of corner slot on the housing.
3. Lift the speaker out from the front housing.
4. Carefully lift microphone assembly out of housing.
Note: T he speaker is held in place with a retainer bracket. Be careful not to damage the speaker
when removing the retainer bracket.
Figure 6-7. Removal Speaker-Microphone Assembly
c. Separate dust b. Rotate dust cover 90
°
to
a. Pry dust cover from body.
key
allow key to be removed.
cover from body.
Retainer Bracket
Radio Housing
Speaker
Speaker Connector
Microphone Connector
Microphone