Motorola PR400 - Manual (Page 78)

July, 2004 6881096C24-A
7-10 Limited Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
3. Insert the Boot and microphone sub-assembly into the microphone recess in the housing and
route wires as shown in
Figure 7-12 .
4. Locate the speaker tab and align it with the tab opening in the front housing ( Figure 7-13 ).
5. Insert the speaker tab into the speaker recess in the housing. Ensure the speaker is seated flush
in the housing.
6. Insert one end of the speaker retainer into the slot in the front housing (See Figure 7-13 ).
Figure 7-12. Microphone Re-assembly
Note: Make sure the speaker and microphone wires are routed tightly between the speaker bas-
ket and the housing post.
Figure 7-13. Speaker Re-assembly
Note: When fastening the speaker retainer screw, make sure the wires are out of the way to pre-
vent pinching by the retainer.
Microphone
Boot
Microphone Recess
Microphone Position
Speaker Retainer
Speaker
Front Housing Slot
Speaker Tab
Tab Opening