Motorola PR400 User Manual
Page 72
July, 2004
6881096C24-A
7-4 Limited Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
4.
Pry off the volume and channel selector knobs from their shafts using the knob remover/chassis
opener tool (Motorola part # 6686533Z01) (
5.
Separate the chassis from the front housing assembly by using the knob remover/chassis opener
tool. Place the broad side of the opener into the slots located at the base of the radio (
Press the handle of the opener downwards. This pressing action forces the thin inner plastic wall
toward the base of the radio, releasing the two chassis base tabs.
.
Figure 7-2. Antenna and Knob Removal
Note: Both knobs slide on and off. However, the knobs are designed to fit very tightly on the shaft.
Figure 7-3. Chassis Removal
CAUTION: Marring the front cover O-ring sealing area will prevent the radio from sealing properly. If the
O-ring is damaged, replace it with a new one.
Note: The speaker wire assembly microphone wire assembly and keypad flex cable connecting
the front housing assembly and the chassis prevent the two units from being completely
separated.
Radio Chassis
Chassis Opener
Knob Remover/
!