MITSUBISHI ELECTRIC SDP-Eco 1630 III - Manual (Page 9)

Chapter1 On Safety
- 1 -
Chapter 1 On Safety
SDP-Eco 1630 III was designed and manufactured with special attention to
safety considerations. However, it is impossible either to eliminate all
potential sources of danger from such products or to anticipate all possible
hazards and misuses. It is therefore critical that you both familiarize
yourself, all your operators and other relevant personnel with all of the noted
precautions, countermeasures and related procedures, and take maximum
care when operating this machine.
1.1 When using the machine
• Grounding connection
- In order to prevent
electric shock at the AC
power supply unit, be
sure to connect the
ground in accordance
with operation site
regulations (resistance:
less than 100 ohms)
using the SDP-Eco 1630
III exclusive wire.
- Even when the user's
present facility outlet can
be with the SDP-Eco 1630 III power plug with ground, make sure that
the ground pole on the outlet is connected with ground in accordance
with operation site regulations (resistance: less than 100 ohms)
Following all relevant local wiring regulations, prepare a grounded
(less than 100 ohms) power supply outlet that can accept this
machine's power plug.
• Power supply
- Prepare a power supply that satisfies all the requirements stipulated in
the specification sheet.
- Always provide circuit breakers for unit or devices that use water or
chemicals.
- Please entrust all wiring, connections and other electrical work to an
authorized electrician.
• Maintenance and safe passage during emergencies
A minimum of 60 cm clearance is required around the machine at all
times to afford adequate space for maintenance and safe passage during
emergencies. Never allow this space to become blocked with any
objects, wires, or other obstacles.
Warning