MITSUBISHI ELECTRIC SDP-Eco 1630 III - Manual (Page 30)

SDP-Eco1630 III USERS MANUAL
A buzzer sounds when you start
inserting the plate. Insert the plate
further until a second buzzer
sounds. At the position where the
buzzer sounds, turn the nip roller
clearance handle back to its
vertical position to close the nip.
Insert the plate edge until
the second buzzer sounds.
If you insert it too far (30
mm or more), the plate
may jam.
Finally, gently holding the right
and left ends of the spool plate
rewind the plate to take up any
slack. Close the plate setting
cover. The plate setting is now
completed.
Skewing or meandering
may occur during feeding
depending on how care-
lessly the plate was
inserted.
Always insert the plate
evenly, holding its left and
right edges with both
hands.
Follow the procedures "4.4 Data
input for the set plate" and
"4.5 Execution of Pre. Feed
command" to input data for the set
plate. To prepare for the exposure:
Remove any section of the plate
that has been fogged by friction
during preliminary feeding.
Caution
Caution
- 22 -
Hold the spool plate to rewind the plate.
Tighten the slack on the
plate roll using both hands.
Close the plate setting
cover.
Insert the plate edge until the second buzzer
sounds and secure it there.
Turn the nip roller
clearance handle back
until it is vertical.