MITSUBISHI ELECTRIC SDP-Eco 1630 III - Manual (Page 29)

Chapter 3 Handling Plates
Confirm that there is no gap
between the plate roll and the
spool plate and that the set screw
is placed in the correct position
and then tighten the set screw.
6) Turn ON the power switch to the
main unit. After completion of the
initialization process, grab the
handle on the right side, open the
magazine cover, and load a plate
roll which has been mounted on a
spool shaft.
Refer to "4.1 Cable
connection check", "4.2
Turning ON the power
switch" and "4.3
Initialization" in Chapter 4
"Operation" when turning
ON the main power
switch.
7) Put the spool shaft holder on the
spool set guide and set the guide
into the SDP-Eco 1630 III.
Position the shaft with its red mark
toward the back of the machine
(on the right side).
8) Turn the nip roller clearance
handle (located at the panel
bottom) until it is horizontal. This
cancels the main roller nipping.
Gently insert the plate into the
clearance in the guide roller.
Note
- 21 -
Gently insert the plate.
Turn the nip roller
clearance handle until
it is horizontal.