MITSUBISHI ELECTRIC SDP-Eco 1630 III - Manual (Page 49)

Chapter 6 User menu
It is possible to set values affecting the machine's operation state from the user
menu. Note that some settings from the host computer are given priority and
they will be automatically changed if the host computer resets them.
Refer to '5.2 Panel operation' for details on key operation.
6.1 Plate data
The command is used to enter information on the plate to be
loaded.
• Data channel
The data channel stores the plate information. 10 different sets of plate
parameter data can be stored (from M0 to M9). The plate information consists
of plate type, plate width, remaining amount, and the set laser (depends on the
resolution for the respective plate type).
• Plate type
You can only use the following three types of plates.
• Plate width
Each plate can be set to the following widths (displayed in mm).
< Plate Data >
Note
Chapter 6 User menu
- 41 -
Plate model
SDP-FRm175
SDP-FR100
SDP-RR175
Panel display
F175
F100
R175
Remarks
Polyester base
t 0.175 mm
Polyester base
t 0.100 mm
Paper base
t 0.175 mm
Plate type
Data
channel Plate width
Remaining
amount
Sample panel display
M 1 F 1 7 5 4 0 4 6 0 m
Plate width(mm) Plate width(inch)