MITSUBISHI ELECTRIC SDP-Eco 1630 III - Manual (Page 75)

Chapter 8 Message
Chapter 8 Message
8.1 Message
The SDP-Eco 1630 III displays three kinds of messages: status messages,
warning messages and error messages.
[Status message]
Status messages indicate the machine's current operation status.
[Warning message]
Warning messages indicate a problem which has no effect currently but may
have adverse effects in the near future. These messages are displayed when
the power is turned ON.
Pressing the
key allows you to continue processing.
[Error message]
Error messages indicate a problem or error which is now occurring during
operation. If an error message is displayed, a buzzer sounds and the machine
will not operate. Pressing the
key while an error message is displayed
stops the buzzer sound.
The following pages contain a listing of common error codes, their meanings,
and corrective measures.
8.2 Displaying and clearing errors
When a problem or error occurs during operation, an error message is
displayed on the display panel and all moving parts, such as the motor, stop.
The machine will not operate while an error message is displayed.
[Error clearance]
Message Contents
ME1 First, stop the buzzer sound by pressing the key
and open the front door. After all required processes are
completed, close the front door and press the key.
This clears the error message.
*Do not turn OFF the main power when JAM1, JAM2,
JAM3 errors occur.
ME3 Turn the nip roller clearance handle until it is vertical
(locked) and then press the key to reset the error.
Others Eliminate the error with the key.
- 67 -
ME2
JAM1
JAM2
JAM3