MITSUBISHI ELECTRIC SDP-Eco 1630 III - Manual (Page 77)

8.5 List of error messages
The following is a list of error messages, and steps that can be taken.
Message Error contents
Serial error An internal communication error occurred. Re-boot the
machine.
If this error occurs frequently, please contact the dealer
where you purchased this machine.
JAM1 The plate is jammed. Remove the plate following the
jam removal procedure.
JAM2 The plate is jammed. Remove the plate following the
jam removal procedure.
JAM3 The plate is jammed. Remove the plate following the
jam removal procedure.
I/F error1 A SCSI communication error occurred. Re-boot the
machine. If this error occurs frequently, please contact
the dealer where you purchased this machine.
ME1 The cutter does not return to its initial position. Turn ON
the power switch again.
ME2 The cutter is not located at its initial position. Turn ON
the power switch again.
ME3 Nip free The nip roller is open. Close the nip roller clearance
handle.
ME4 An internal communication error occurred in the
machine. If this error occurs frequently, please contact
the dealer where you purchased this machine.
ME5 An internal communication error occurred. Re-boot the
machine.
If this error occurs frequently, please contact the dealer
where you purchased this machine.
ME6 The laser does not light. It may be caused by low laser,
but if it occurs even after you boost the laser, please
contact the dealer where you purchased this machine.
ME7 A problem occurred in the polygon mirror. Please
contact the dealer where you purchased this machine.
ME8 A problem occurred in the processor heater. Please
contact the dealer where you purchased this machine.
Chapter 8 Message
- 69 -