MITSUBISHI ELECTRIC SDP-Eco 1630 III User Manual

Page 54

SDP-Eco1630 III USERS MANUAL

• The alarm function in this machine has been set to OFF before shipment at

the factory.

(Settings 000 = OFF)

• The consumption rate of rinse water may be different depending on the

settings in the machine. Set the consumption rate with the following

procedure.

[Procedure] (In cases where the current values are changed to "150".)

(1) Push the

key to display the

window.

(2) Select

with the

key, and then push the

key.

(3) When

is displayed, make sure that the cursor is placed

under the setting, and then push the

key.

(4) Push either the

key (Increase) or the

key (Decrease) to set the

settings to "150".

(5) After changing the setting, push the

key to confirm the setting.

(6) Push the

key two times to display the

window.

Use "120 to 160" as a reference value. Adjust the rate of rinse water reduction

depending on the installation conditions of the machine.

(Adjustable range: 50 to 300. Note that using "000" deactivates this function.)

[Notes for adjustment]

(1) When the "Rinse Tank Check" message is displayed.

If the replenishing bottle is empty, decrease the setting.
If there is a lot of rinse water left in the bottle, increase the setting.

(2) To deactivate the software counter function, use "000" as a setting value.

Be sure to reset the counter by "CLR" after you have adjusted the setting.

Note

< Plate Data >

ENT.

Count 150 CLR

ENT.

< Rinse >

< Plate Data >

- 46 -