6 exposure – MITSUBISHI ELECTRIC SDP-Eco 1630 III User Manual

Page 37

Chapter 4 Operation

- 29 -

4.6 Exposure

The machine has two exposure modes: remote exposure which performs
exposure using data provided from the host computer, and local exposure
which performs laser test exposure and re-exposure.

•

Remote exposure

After entering remote mode (ON LINE lamp is lit), give the exposure
command through the host computer (RIP computer). While exposure is in
progress, "Exposing ***%" is displayed on the panel display. "***%"
indicates the percentage currently exposed.
[Display during remote exposure]
The panel display changes as shown below during the exposure.

•

Local exposure

[Laser Test Expo.]
(1) Confirmation and input of the plate type, resolution and light intensity

1) Use the

key to call up

display.

2) Select

using the

key and press the

key.

3) Press the

key while

is displayed.

4) Plate type, resolution and light intensity are displayed.

(Example)

(F175 1200 dpi Light intensity 200)

5) Press the

key to change the resolution. Select the desired

resolution from among 12 (1200 dpi), 15 (1500 dpi), 18 (1800 dpi)
and 24(2400dpi) using the

key. Register the resolution using

the key.

6) Press the

key to move the cursor to the light intensity value

display and then press the

key.

7) Change the light intensity value using the

key or the

key.

Press the

key to register the light intensity value.

Press the

key to return to the previous menu if no change is necessary or

setting is discontinued.

Note

ENT.

F 1 7 5 ( 1 2 ) 2 0 0

Laser Test Expo.

ENT.

< Plate Data >

Data transmission start
Data transmission end

Data Transferring

Image data exposure start

Exposing 0%

Image data exposure end

Plate is being discharged

Exposing 100%

Discharging

Completion

Complete