MSI MS-6566 - Manual (Page 57)

Chapter 3
3-16
Note: If you change these settings, you must reboot the system until it
enters the operating system and then power off the system. By doing
so, the changed settings will come into effect next time when you
power on the system.
Wake Up On Ring
When setting to Enabled, the feature allows your system to be awakened from
the power saving modes through an incoming call from the modem. Settings:
Enabled and Disabled.
Wake Up On PME
When setting to Enabled, the feature allows your system to be awakened from
the power savi ng mo des th rough any event on PM E (Po wer Ma nagement
Event). Settings: Enabled and Disabled.
Resume By RTC Alarm
This is used to enabl e or disable the feature of booti ng up th e system on a
scheduled time/date from the soft off (S5) state. Settings: Enabled and Disabled.
RTC Alarm Date/Hour/Minute/Second
If Resume By RTC Alarm is set to Enabled, the system will automatically
resume (boot up) on a specific date/hour/minute/second specified in these
fields. Available settings for each item are:
Alarm Date 01 ~ 31, Every Day
Alarm Hour 00 ~ 23
Alarm Minute 00 ~ 59
Alarm Second 00 ~ 59
Power Again
This setting specifies whether your system will reboot after a power failure or
interrupts occurs. Available settings are:
Power Off Leaves the computer in the power off state.
Power On Reboots the computer.
Last State Restores the system to the status before power failure or
interrupt occurs.
Note: You need to install a modem supporting power on function for
Wake Up On Ring function.