MSI MS-6566 - Manual (Page 43)

Chapter 3
3-2
Entering Setup
Power on the computer and the syst em will start POST (Po wer On Self
Test) process. When the message belo w appears on the screen, press
key to enter Setup.
DEL:Setup F11:Boot Menu F12:Network boot TAB:Logo
If the message disappears before you respond and you still wish to enter
Setu p, restart th e syst em by t urning it OFF and On or p ressing the R ESET
button. Yo u may also restart the system by simultaneously pressi ng ,
, and keys.
Selecting the First Boot Device
You are allowed to select the 1st boot device without entering the BIOS
set up u tili ty by pre ssin g . When the same message as l iste d ab ove
appears on the screen, press to trigger the boot menu.
The POST messages might pass by too quickly for y ou to respond in
time. If so, restart the system and press after arou nd 2 or 3 seconds to
activate the boot menu similar to the following.
The boot menu will list all the bootable devices. Select the one you want
to boot from by using arrow keys and then pressing . The system will
boot from the selecte d device . The se lection will not make ch anges to the
settings in the BIOS setup utility, so next time when you power on the system,
it will still use the original first boot device to boot up.
Select First Boot Device
Floppy : 1st Floppy
IDE-0 : IBM-DTLA-307038
CDROM : ATAPI CD-ROM DRIVE 40X M
[Up/Dn] Select [RETURN] Boot [ESC] cancel