Decode session timeout, Fuzzy 1d decoding, Decode session timeout -8 fuzzy 1d decoding -8 – Motorola DS3478 User Manual
Page 62
4 - 8
Symbol DS3478 Product Reference Guide
Decode Session Timeout
This parameter sets the maximum time decode processing continues during a scan attempt. It is programmable in
0.1 second increments from 0.5 to 9.9 seconds. The default timeout is 3.0 seconds.
To set a Decode Session Timeout, scan the bar code below. Next, scan two numeric bar codes from
that correspond to the desired on time. Enter a leading zero for single digit numbers. For
example, to set a Decode Session Timeout of 0.5 seconds, scan the bar code below, then scan the 0 and 5 bar
codes. To correct an error or change the selection, scan Cancel on
Fuzzy 1D Decoding
Enable this parameter to increase aggressiveness when decoding significantly damaged 1D symbols. Disabling
this parameter reduces decode aggressiveness on such symbols, but increases decode aggressiveness on 2D
symbols.
Decode Session Timeout
NOTE
123Scan does not support this option.
*Enable Fuzzy 1D Decoding
Disable Fuzzy 1D Decoding