MITSUBISHI ELECTRIC WT03939X20 - Manual (Page 60)

59
(10) Send the settings.
Click [Send settings].
When the Settings will be sent. OK? message appears,
click [Yes].
Setting begins.
When setting is completed, the Settings have been sent
message appears.
Click [OK].
The MN Converter switches to remote error notification mode.
NOTE:
If you selected "Connection with host SC", you must register the address of the MN Converter
on the host SC.
Caution:
After specifying the error notification settings, always run the error notification test to check that
notification is correctly provided to the correct addresses.
[See section 3.12.4].
NOTE:
MN Converter is registered with a unit targeted for error monitoring as attribute SC. When five
SC is already register with a unit targeted for error monitoring, the following messages are
displayed and you cannot register MN Converter with a unit. Please confirm connection
relations.