MITSUBISHI ELECTRIC WT03939X20 - Manual (Page 106)

105
3.13.5.1 Starting the interlock control settings on AI Controllers
The password is needed to make the settings for interlock control. Only the allowed administrator can perform
the settings. To make the settings, enter the password first to be identified as an administrator. The
procedures are shown below. The setting procedures are the same for DIDO Controllers.
Refer to section [3.13.4.1 Starting the interlock control settings on DIDO Controllers ].
3.13.5.2 Interlock control settings on AI Controllers
(1) Click [Option] in the menu bar and
select [DIDO/AI/PI] -> [DIDO/AI interlock setting] in
the sub-menu.
(2) Click of the unit (AI Controller)
to be monitored on the Main screen.
(3) AI controller (63MC) interlock control
setting screen will appear.
(4) Click the checkbox of [I agree] to accept the
agreement.
(5) The interlock control settings is monitored,
and AI controller (63MC) interlock control
setting screen will appear.
[Interlock No.]
The pattern No. of interlock control
setting is shown. Up to 24 patterns
can be set.
[Ch No.][Interlock operation conditions]
The Ch No. of the interlock source and the
interlock condition (condition based on the
measurement value) are shown.
Caution:
Read the agreement carefully.