Motorola D1110 - Manual (Page 36)

36 Using additional handsets
13. Using additional handsets
You can use up to five D1111 additional handsets with your D1111 base
to extend your phone system without needing to install extension sockets
for each new phone.
Your D1111 handset can also be registered to up to 3 other bases. You
can then select the base you would prefer to use.
If you have purchased a D1111 multiple pack any additional handsets
come pre-registered to the base.
If you have purchased an additional handset separately you must register
it to your D1111 base before it can be used.
Registering an additional handset
At the base:
1. Press and hold
p
for 2 seconds until the base Power starts flashing.
The base will remain in registration mode for 90 seconds.
At the handset:
1. If the handset is new and the display shows
Please Register . Press Menu .
Scroll
u
to Registration . Press Select .
Or
If the handset has already been registered to another base the
standby display is shown. Press Menu , scroll
u
or
d
to Registration and
press Select .
2. Register Handset is highlighted. Press Select .
3. Bases are displayed. If necessary, scroll
u
or
d
to a new base you
wish to register your D1111 handset to and press Select .
4. Enter the system PIN and press OK . (Default setting = 0000)
5. The display shows Searching Base X (where X is the chosen base
number) then Handset Registered .
The handset is automatically assigned the next available handset
number.
If registration is not successful first time, please repeat the process again
in case the base registration period ran out of time.
If there are already 5 handsets registered to the base, the registration will fail.
You must de-register another handset before you can register the new one.
Select a base
If your D1111 handset is registered to more than one base, you can select
which base to use.
1. Press
Menu , scroll
u
or
d
to Registration and press Select .
2. Scroll
d
to Select Base and press Select .
3. All base numbers are displayed. (In use) is added to bases where the
handset was previously registered to. Scroll
u
or
d
to the base you
want and press Select .
4. Display shows Searching Base… . then the standby display for that base.
De-register a handset
Use one handset to de-register another. You cannot de-register the
handset you are using.
1. Press
Menu , scroll
u
or
d
to Registration and press Select .
2. Scroll
d
to De-register and press Select .
3. Enter the system PIN and press OK . (Default setting = 0000)
4. Scroll
u
or
d
to the handset you want to de-register and press Select .
5. Press Yes to confirm or No to cancel.
6. Press Back to return to the previous menu level or
>
to return to
standby.