Motorola D1110 - Manual (Page 32)

32 Text messaging
Insert Emoticon Press Select . The Emoticon table is displayed. Press
u
or
d
to highlight the Emoticon you want then press
Insert .
Insert Template Press Select . The list of templates is displayed. Press
u
or
d
to highlight the Template you want then press
Insert .
5. When sending a message, the display shows Sending Message then
Message Sent .
WRITING TIPS
Press
Clear to delete incorrect characters.
Use
u
or
d
to move the cursor through the text, if you want to insert/
delete text.
UPPER & LOWER CASE
Press
#
to switch between upper case and lower case letters.
Maximum number of characters in a text message is 160. The display
shows a character countdown from 160 down to 0 (Unless message size
is set to 612 characters).
If the text is unsuccessful, the message
Message Sending Failed! will be
displayed.
In order to send and receive text messages you must not withhold your
number.
Standard text entry
With standard text entry you can enter a word by pressing each letter
button a number of times to display the character you want on the screen.
For example, to write the word “Hello”, press
4
twice,
3
twice,
5
three times,
5
three times and
6
three times.
Receiving and reading text messages
Your D1111 can store up to a total of 50 short messages across all
handset Outboxes, Drafts boxes and Inboxes.
When you receive a new text message, the
icon is displayed along
with You have X new messages .
DO YOU HAVE TWO TEXT PHONE BASES CONNECTED TO THE
SAME PHONE LINE?
If you have two text phone base stations plugged into one line, you are
likely to experience problems receiving text messages. Normally, only
one SMS enabled base unit (DECT or cordless) can be plugged into any
line.
If you do want to use two base units and still receive written text you must
delete receive service centre number from one of the base stations. To
do this on your D1111, see page 34.
This will allow you to send text via either base station but texts will only
be received on the product with the active receive centre number.
If the base unit with the active receive centre number is a DECT product
then all handsets registered to will be able to receive text messages.
MEMORY FULL ALERT
If the text mailboxes are full when you attempt to write a new message
the display shows
Memory Full Delete Messages . You must delete messages
before you can write and send a new one.
Read a new message
Received messages are stored in the Inbox.
1. The Inbox is opened and the list of messages displayed. If you press
Back the message is stored in the Inbox for reading later.
2. In the Inbox scroll
u
(to more recent messages) or
d
(to earlier list of
messages) through the list of messages.
3. Highlight the message you want to read and press Read or press Back
to return to Text messaging menu.
4. Press
>
to return to standby.