Mitel 5606 - Manual (Page 48)

5606 Wireless Handset User Guide
42
Troubleshooting
Figure 6: Trouble-shooting the 5606 Wireless Handset.
Problem Solution
The handset does
not start Check that the correct battery type is used. "Only to be used in
RAID2-XXXXX" should be printed on the label on the battery,
see page 2. If the battery is correct ensure it is fully charged.
The handset beeps once a minute (during max
30 minutes) with a low tone followed by a high
tone (if enabled, the vibrator also follows the
beeps)."No System" appears in the display.
(It is possible to adjust the beep volume via the
ring signal volume setting.)
The handset is out of coverage: Stop the beep with the mute
button and move into range.
Note: When re-entering the coverage area it can take a couple
of minutes before the handset automatically registers into the
system.
or
It is a no system warning: Remove and then insert the battery
again to make the handset connect to the system
automatically.
Poor voice quality For best voice quality, avoid positioning near computer, radio or
similar electronic device.
Figure 4.
035
No
No
No
Working?
Try with
another SIM
My handset does not work
Try with
another
battery pack
Yes
Yes
Yes
Yes
Order a new
SIM
Order a new
battery pack
Try on another
location/
against another
base station
Consult the
installer for advice
Consult the
installer for advice
Send the handset
for repair
No
Are there more
handsets with
the same
problem?