Motorola DIGITAL DS6708 - Manual (Page 178)

13 - 2 Symbol DS6708 Digital Scanner Product Reference Guide
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
Symbology Parameter Defaults
Table 13-1 lists the defaults for all symbologies parameters. There are two ways to change the default values:
• Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
Set Default Parameter on page 4-4 .
• Configure the digital scanner using the 123Scan configuration program (see Chapter 12, 123Scan ).
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, and miscellaneous default
parameters.
Table 13-1 Parameter Defaults
Parameter
Parameter
Number
Default
Page
Number
UPC/EAN
UPC-A 01h Enable 13-7
UPC-E 02h Enable 13-7
UPC-E1 0Ch Disable 13-8
EAN-8/JAN 8 04h Enable 13-8
EAN-13/JAN 13 03h Enable 13-9
Bookland EAN 53h Disable 13-9
Decode UPC/EAN/JAN Supplementals (2 and 5 digits) 10h Ignore 13-11
User-Programmable Supplementals
Supplemental 1:
Supplemental 2:
F1h 43h
F1h 44h
13-13
UPC/EAN/JAN Supplemental Redundancy 50h 10 13-13
Transmit UPC-A Check Digit 28h Enable 13-14
Transmit UPC-E Check Digit 29h Enable 13-14
Transmit UPC-E1 Check Digit 2Ah Enable 13-15
UPC-A Preamble 22h System Character 13-16
UPC-E Preamble 23h System Character 13-16
UPC-E1 Preamble 24h System Character 13-18
Convert UPC-E to A 25h Disable 13-19