Stop bit select, Data bits, Stop bit select -11 data bits -11 – Motorola DIGITAL DS6708 User Manual
Page 109
RS-232 Interface 7 - 11
Stop Bit Select
The stop bit(s) at the end of each transmitted character marks the end of transmission of one character and
prepares the receiving device for the next character in the serial data stream. Select the number of stop bits (one or
two) based on the number the receiving terminal is programmed to accommodate. Set the number of stop bits to
match host device requirements.
Data Bits
This parameter allows the digital scanner to interface with devices requiring a 7-bit or 8-bit ASCII protocol.
*
1 Stop Bit
2 Stop Bits
7-Bit
*
8-Bit