Minolta PageWorks/Pro 18 - Manual (Page 153)

A.4 BUS Handshake
A-4
Jumper Settings
Appendix A
A.4 BUS Handshake
The bus handshake signal may be altered to match with your printer
controller. Normal handshake signal is WAIT- signal (OP3 set to pins 2
and 3). Check your printer manual to determine if your controller
requires the alternate handshake signal ACK/RDY-(OP3 set to pins 1
and 2).
A.5 Network Bridging
This jumper is only set for Token Ring designs. The jumper selects
between Source Route Bridging (Default: OP4 set to pins 2 and 3) and
Transparent Bridging (OP4 set to pins 1 and 2). Select the setting that
is compatible with the bridge architecture of your network.
PageWorks.book Page 4 Tuesday, August 4, 1998 11:21 AM