Grizzly 1 1/2 HP Cyclone G0703 - Manual (Page 23)

Model g0703/g0703p (Mfg. Since 3/12)
-21-
17. place the drum lid onto the drum and tighten
the latches, then roll the drum under the
cyclone port so the drum spout faces the dust
collector, as shown in
figure 26.
figure 25. Bag installation.
16. install the dust collection bag into the collec-
tion drum as shown in figure 25.
19. Connect the other end of both hoses to the
cyclone housing (see figure 27), and secure
them in place with the appropriate diameter
hose clamps.
18. Connect the 1" hose and the 7" hose to the
collection drum.
figure 26. Collection drum positioning.
drum
lid
Spout
20. install the filter element dust bag (figure 27)
to the filter, and clamp it in place with the
spring clamp.
tip: To make filter-element bag installation
easier, use a piece of tape to hold the bag in
place while the clamp is positioned and tight-
ened.
21. Fasten one end of the ground wire (figure 27)
to the copper screw in the drum lid and the
other end to the stand, using an existing
5 ⁄
16
"-
18 hex bolt.
figure 27. hose and bag installed.
ground
Wire
1" hose
7" hose
dust
Bag